BLUENOTE Phono 2 Owner's Manual page 11

MATCHING THE CARTRIDGE GAIN
CLEANING THE PHONO STAGE
F.A.Q. & Adjustment
•
Your cartridge needs a proper
GAIN matchin g to
between MM or MC.
•
The Phono Stage is dirty and
needs to be cleaned
To have only move the following 2 micro
switches:
•
470ohm (MC TYPICAL) impedance move the
2, 3 switches towards the "ON" labelled side.
•
47Kohm (MM TYPICAL) impedance move the
2, 3 switches towards the "2 & 3" labelled side.
•
Once you disconnect the Phono Stage from the
chose AC plug remove, taking extreme care, the acrylic
circular bottom. The signal cables are soldered to
the connectors of such bottom so please doing
that operation with great attention. Inside the
Phono stage is visible the RED PCB where a
DIPSWITCH with 4 switches is installed. To
have only move the following 2 micro switches:
•
MC move the 1, 4 switches towards the "ON"
labelled side.
•
MM move the 1, 4 switches towards the "1 & 4"
labelled side.
•
With EXTREME care use ONLY pure alcohol
and a very soft 100% cotton cloth to sweep dust
and stains out.
Any acid or not extremely soft cloth will irreversibly
damage the Phono Stage fine aesthetic.
Do not use any alcohol to clean the Phono Stage anodised
label, or printed parts. Only dry cloth is allowed
9