User Guide; Preparation - KENT Batch 9215 Instruction Manual

Date: 18/4-2017
 Kent hojtryk\Clean-9200-9300-1500\Brugs-9200-6300-1500-EN-c.doc

2. User guide

2.1 Preparation

The high-pressure cleaner must be moved by use of either a forklift truck,
by rigging it directly onto a pallet with the high-pressure cleaner securely
fixed, or lifting by crane with the shown lifting bracket No. 19664, as
mentioned in section 4.1.
The high-pressure cleaner must be switched off and, if possible, cooled
down during handling.
Weight 95 -105 kg depending on model. Please see previous list.
Never lift higher than 0,5 m and never lift above persons. Connect power and water only when the unit
is placed on a stable and level surface.
This unit has been tested and test-run in the factory, but after transportation it may require a fine
adjustment and visual check of all operations. Always check for loose wires, screws and defect joints.
Pay particularly attention to thread connections and the equipment fittings at the outlet and inlet
connections on the high-pressure cleaner.
The work must always be planned in compliance with good ergonomic principles, and breaks must be
organized during large and continuous tasks. Avoid straining of back and arms and plan the work day
after consulting management and avoid stress. Vary your work or take appropriate breaks in order to
avoid monotonous strain.
Check oil level through pump indicator glass. Change oil after 25 hours of operation. Then after each 200
hours of operation. Use a good motor oil, SAE 20/30.
Check that the machine is plugged into correct mains voltage.
Check water filter, MUST be free of dirt.
Check that the motor protection is switched off.
Connect electric cable (Approved socket or fixed installation).
See Electrical data (annex 4.4)
Connect the water supply to the cold-water cleaner by a 3/4 inch. fabric-reinforced hose. Use tap
water or "reject water" (treated waste water), if available.
High-pressure cleaners.
Instruction manual
Outlet connection
Inlet connection
Batch - 92/9300 - ST 1500
Make sure that personal protective equipment is
within reach. We recommend that operators
wear protective clothing, protective goggles,
gloves and safety footwear during operation of
the high-pressure cleaner.
Page: 6 of 36