ADC ADSCOPE 600 Instructions For Use Manual page 5

Replacing Faceplates (618 Models)
Removal: Hold the chestpiece with one hand.
Pop off the old plate diagonally from behind.
Replace: Position the bottom of the new plate to the socket of the
chestpiece. Snap the top firmly into place.
Replacing Eartips
To replace Adsoft TM Plus Eartips: Slide Adsoft TM PLUS eartip over adapter until it
locks tight into internal channel. Repeat steps for second aural tube.
Cleaning, Disinfection, and Storage
• Clean your Adscope between patients using either a 70% isopropyl alcohol
solution, 70% isopropyl alcohol wipe, or disposable wipe with soap and water.
Be sure to wipe down all surfaces including chestpiece, tubing, headset and eartips.
• The diaphragm, non-chill bell ring, and eartips may be removed for a thorough
cleaning if desired. Ensure all parts are thoroughly dry before reassembling.
Do not remove chestpiece.
• If storing in original box, the molded tray (all models except 609) may also be
wiped down to reduce risk of re-contamination.
• Avoid extreme heat, cold, solvents or oils.
• Do not leave exposed to direct sunlight for prolonged periods of time.
• Periodically check that eartips are securely affixed to the headset and freefrom
dam-age.
• Do not immerse stethoscope in any liquid.
• Do not steam sterilize. If sterilization is necessary gas sterilize only.
5