Component Engineering Ta-10 Setup - GDC LPU-1000 Installation Manual

15. COMPONENT ENGINEERING TA-10 SETUP

Component Engineering TA-10 Setup
15.
The Component Engineering TA-10 can be used for theater automation with the LPU-1000. It requires that the
TA-10 be wired in a particular configuration. A wiring diagram can be seen below.
The TA-10 is connected to the LPU-1000 using the server's GPIO input/output port. Configure event labels with
the GPIO device to trigger the TA-10.
16. TESTING PROCEDURES AFTER INSTALLATION
After the installation has been completed, it is necessary to test the following to ensure that the LPU-1000 has
been properly installed:
1. Test the video playback capabilities of the server using the following file formats: MPEG2, JPEG2000,
Scope, Flat, 3D.
2. Test the audio playback capabilities of the server and verify that all the channels are working. Also check
for any static noises.
3. Test the server's ability to activate automation cues using test cues for lights, curtains, sound and fire
alarm.
4. Test the remote access capabilities of the server, including: Theatre Management System (TMS) access,
network connectivity and VNC.
INSTALLATION MANUAL FOR LPU-1000 LED PLAYER UNIT
Figure 57 Component Engineering TA-10 wiring diagram.
-83- 26 Feb 2018