Automation Setup For Christie Act Devices - GDC LPU-1000 Installation Manual

14. AUTOMATION SETUP

14.4 Automation setup for Christie ACT devices

The LPU-1000 supports Christie ACT automation device. Follow the steps below to configure a Christie ACT
device in the server automation interface.
1. Click [Add] under [Devices] and enter the name of the device. In this case, it is [ChristieACT]. Set the
device type to [ChristieACT].
2. Click [OK] and set up the device parameters for the Christie ACT device.
1
3. Enter the IP address of the Christie ACT device.
4. The default setting for the [Port] is displayed on the settings for the Christie ACT device. Change this value
if required.
5. Default control cues will be set up for a new Christie ACT automation device. Control cues can be added or
removed by clicking on the [+] and [-] buttons.
INSTALLATION MANUAL FOR LPU-1000 LED PLAYER UNIT
2
Christie ACT automation device setup
-73- 26 Feb 2018