Front Panel Controls - Sherwood Newcastle R-863 Operating Instructions Manual

Front Panel Controls

TUNING/PRESET MODE BUTTON MULTI ROOM
BAND BUTTON
TUNING/PRESET UP/DOWN
( / ) BUTTONS
MULTI CONTROL KNOB
MULTI CONTROL
PHONES
HEADPHONE JACK
SPEAKER BUTTON
POWER SWITCH
CHANNEL SELECTOR BUTTON
TEST TONE BUTTON
STANDBY BUTTON/INDICATOR
I FLUORESCENT DISPLAY
VIDEO INPUT INDICATORS TUNED INDICATOR
ROOM 2 INDICATOR
LOCK INDICATOR
SURROUND MODE
INDICATORS
TAPE MONITOR
INDICATOR
LOCK
INPUT SIGNAL
INDICATORS
AUTO INDICATOR
INPUT, FREQUENCY, VOLUME LEVEL, OPERATING INFORMATIONs, etc.
REMOTE SENSOR
SOURCE DIRECT BUTTON
ROOM 2 BUTTON
R-863
AUDIO/VIDEO SURROUND RECEIVER
BAND T/P MODE
MULTI ROOM
REMOTE SENSOR
LOCK LOCK
TUNING/PRESET
INPUT SELECTOR
POWER
AUDIO VIDEO TAPE MON. 7.1CH DIRECT
STANDBY
ON/STANDBY
ON / OFF
CHANNEL
SPEAKER
TEST TONE TONE MODE
SELECTOR VIDEO LABEL MEMO/ENTER
ON/OFF
TAPE MONITOR BUTTON
MEMORY/ENTER BUTTON
VIDEO SELECTOR BUTTON
VIDEO LABEL BUTTON
TONE MODE BUTTON
AUDIO SELECTOR BUTTON
STEREO INDICATOR
SOURCE DIRECT INDICATOR
AUTO TUNING INDICATOR
MEMORY INDICATOR
PRESET INDICATOR
CHANNEL
INDICATORS
SPEAKER INDICATOR
SLEEP INDICATOR
MUTE INDICATOR
CINEMA EQ BUTTON
DYNAMIC RANGE BUTTON
E X T E N D E D
MASTER VOLUME
SOURCE
DIRECT CINEMA EQ
DYNAMIC
ROOM2 FEED RANGE
SURROUND MODE
DECODING EXTRA SURR. STEREO DIGITAL/ANALOG
6.1/7.1
OPTICAL IN S-VIDEO VIDEO
DIGITAL/ANALOG BUTTON
STEREO BUTTON
EXTRA SURROUND 6.1/7.1 BUTTON
DECODING MODE BUTTON
7.1 CH DIRECT BUTTON
I VIDEO 4 INPUT JACKS
OPTICAL IN
Additional video component
OPTICAL OUT
S-VIDEO OUT
• The VIDEO 4 input jacks may be also connected to an additional video
component such as a camcorder, a video deck or a video game player,
etc.
Use the S-VIDEO jack to make connection to video component with the
S-VIDEO OUT jack.
• A signal input into the normal(composite) VIDEO jack will be output
in the normal(composite) VIDEO OUT jacks and a signal input into the
S-VIDEO jack will be output in the S-VIDEO OUT jacks.
• The OPTICAL DIGITAL OUTs of the component that are connected
to CD, TAPE MONITOR and VIDEO 1~VIDEO 4 of this unit can be
connected to this OPTICAL IN.
• After making digital connections, be sure to match the DIGITAL INs to
the corresponding input source respectively.(For details, refer to "When
selecting the DIGITAL IN SETUP" on page 37.)
• This OPTICAL IN should be connected to the component capable of
DTS, Dolby Digital or PCM format digital signals, etc.
9
MASTER VOLUME
CONTROL KNOB
W R A S
WIDE RANGE AMPLIFIER STAGE
L - AUDIO - R
S-VIDEO VIDEO L - AUDIO - R
AUDIO OUT
VIDEO OUT