Connecting Speakers - Sherwood Newcastle R-863 Operating Instructions Manual

I ROOM 2 connections
• If another A/V receiver or integrated amplifier, etc. is connected to these jacks, you can play a different program source in another
room as well as one source in the main room at the same time.(For details, refer to "ROOM 2 SOURCE PLAYBACK" on page 31).
• When the multiroom adaptor is connected to control this unit in another room, the ROOM 2 function is more convenient.
Note:
• To minimize hum or noise, use high quality connection cords in such a way that there is no humming or noise.
I CONNECTING MULTI-ROOM
SYSTEM KIT
OUT
Adaptor
(Multi-room system kit)
• To control this unit from a remote location, connect this jack
to the output of the multi-room adaptor.
For information on the multi-room system kit, contact the
Xantech corporation at 1-800-843-5465 or www.xantech.com.
I CONNECTING SPEAKERS
Front left
Front right
Surround
right
Surround back
right
• Never short circuit the + and - speaker wires.
• Be sure to connect speakers firmly and correctly according to the
channel (left and right ) and the polarity ( + and -).
• Be sure to use speakers with the impedance of over 6 Ω.
• Only when enjoying either 6.1 or 7.1 channel surround playback,
connect the surround back left speaker only or both of surround
back speakers.
Note:
• After installing the speakers, first set the connected speakers to the
desired before operating this receiver.(For details, refer to
"SETTING THE SPEAKER SETUP" on page 34.)
Another room
VIDEO IN
AUDIO IN
Another room
IR receiver Remote control unit
(Multi room system kit)
Front
center
Surround
left
Surround back
left
8
Monitor TV
Speakers
A/V receiver
or amplifier
I SWITCHED AC OUTLETS
• These outlets are switched on(power-on
mode) and off(standby mode) according
to the power control as follows(Maximum
total capacity is 1A, 100W):
Standby mode – switched AC outlet off
Power-on mode – switched AC outlet on
I AC INLET
Plug the supplied AC input cord into this AC
INLET and then into the wall AC outlet.
• Do not use an AC input cord other than the one
supplied with this unit. The AC input cord
supplied is designed for use with this unit and
should not be used with any other device.
To a wall AC
outlet.