9100-0425-01
•
Rate specified for when device is In Motion. (Note, when inside the Change of Location Area, this
rate affects sampling, but not reporting, as indicated by a higher priority for inside Change of
Location Area.)
•
Rate specified for when the device is At Rest.
Message Priorities
It is possible that message types may collide. Whenever feasible, the SmartOne will examine its known
schedule and reschedule lower priority messages to occur after higher priority ones. If there is not enough
time in the known schedule for all scheduled messages to be transmitted in a reasonable time, or there is
insufficient memory to queue them, the lowest priority message(s) could be dropped. In any case,
unscheduled messages (for example, Input Status Changed) shall cancel pending messages of lower
priority and not cancel pending messages of higher priority. The following list shows the priority of
message types, with the highest priority being listed first.
•
Contact Service Provider
•
User Defined Raw message. *
•
User Defined Truncated message. *
•
Change of Location Area
•
Replace Battery Solar product does not require this message
•
Undesired Input State
•
Re-Center
•
Diagnostics
•
Accumulate/Count
•
Input Status Changed
•
Device Turned On
•
Normal Location (In-Motion or At-Rest).
*Note: The two user defined message types actually have equal priority. Either one will cancel the
other one. If, for example, the user interface commands the device to send a Truncated
message, and then, before it has time to obtain a fix and send the message, the user
commands a Raw message, the Raw message will be sent.
SmartOne Solar™ User Guide v1.0.3
Confidential & Proprietary Information
19