Almost Heaven Saunas Harvia Installation Manual

Almost Heaven Saunas Harvia Installation Manual

Advertisement

Harvia Heater Installation Guide
Revised April 2017

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Harvia and is the answer not in the manual?

Questions and answers

Summary of Contents for Almost Heaven Saunas Harvia

  • Page 1 Harvia Heater Installation Guide Revised April 2017...
  • Page 2 This brief guide is intended to supplement the manufacturer’s manual and will give you simple instructions on how to install the Harvia heater in your Almost Heaven Sauna. A li- censed electrician should perform all electrical work, and Almost Heaven Saunas is available to assist with any questions you or your electrician may have.
  • Page 3 Temp Sensor Sensor Cable Temp Sensor 3. The temp sensor housing is 5. Remove the temp sensor and 4. Turn the heater on it’s back and attached to the heater element remove the bottom cover to ex- carefully uncoil the sensor cable with a zip tie.
  • Page 4: Timer Operation

    9. At this point, it’s time to switch on the heater, so turn on the breaker. There is a non-toxic coating on the heater elements, and the purpose of this preliminary heating stage is to burn that coating away. It is normal for smoke to appear, so keep the door open to prevent it from leaving a black residue on the ceiling.
  • Page 5 Sensor Cover 11. Mount the metal temp sensor 12. Conceal the temp sensor by housing vertically on the wall and mounting the sensor cover. Place 12” to the right or left of the heat- the cover over the temp sensor er.
  • Page 6: Troubleshooting

    Was the proper wire size and amp size used? HIGH LIMIT CONTROL Your Harvia Heater is equipped with a built-in high-limit control, which is a safety device. If an abnormal heating condition should occur, the heater will automatically shut off. Once the room as cooled, manually reset the heater by pushing the reset button.

Table of Contents