IgniteNet MetroLinq 60 LW Quick Start Manual

Q ui c k Sta r t G u id e
Cloud-Enabled Outdoor 60 + 5 + 2.4GHz PTP/PTMP
MetroLinq™ 60 LW
1. Unpack the MetroLinq
Package Contents
◆
MetroLinq™
Tools/Items Required
◆
Flat-head screwdriver
◆
Ethernet cables
2. Mount the MetroLinq on a Pole
1
1 Slide the pole-mount bracket onto the rails on the back of
the AP until it snaps into its secured position.
2 Use the included M3 screw to secure the bracket to the AP.
3
3
3 Feed the two steel-band clamps through the pole-mount
bracket mounting points.
4 Fasten the steel-band clamps around the pole to secure the
AP to the pole.
ignitenet.com
60 LW (ML-60-LW)
2
4
4
– 1 –
3. Grounding
2
1
1 Ensure the structure on which the unit is to be mounted is
properly grounded and in compliance with ETSI ETS 300 253.
2
Verify that there is a good electrical connection to a
grounding point (no paint or isolating surface treatment).
Use the included (M4) screw to attach a grounding wire (not
included) to the grounding point on the unit, and then to
ground.
Caution:
The earth connection must not be removed
unless all supply connections have been disconnected.
4. Connect Cables
1
1 Connect outdoor-rated Category 5e or better cable to the
RJ45 port. (The other end of this cable connects to the PoE
power injector.)
2 Install a 1G SFP transceiver in the SFP port, and then connect
fiber optic cabling to the transceiver.
The following transceivers are supported:
◆
1000BASE-SX
◆ 1000BASE-LX
5. Connect Power
a. Using the PoE Power Injector
3
2
1 Connect outdoor-rated Category 5e or better cable from the
MetroLinq to the POE port on the power injector.
2
1
E012018-CS-R01