Connections; Power Supply; Connecting To Video Equipment - Sharp XV-Z9000U Operation Manual

Connections

Power Supply

Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the projector.
CAUTION
• Make sure the power cord is firmly connected into the AC socket.
• The projector will enter the stand-by mode after turning the power off and then re-plugging the power cord into the AC socket. However,
if you turned off the power by disconnecting the power cord or because of a power failure, the projector will automatically turn on without
pressing the POWER ON button.

Connecting to Video Equipment

You can connect your projector to a VCR, laser disc player, DVD player, DTV* decoder and other video equipment.
* DTV is the umbrella term used to describe the new digital television system in the United States.
CAUTION
• Make sure to turn both the projector and the video equipment off, before connecting.
• As this projector is not equipped with audio input terminals, commercially available audio equipment or your own equipment (such as
speakers or amplifiers) should be used.
Connecting a video source (VCR, laser disc player, DVD player or DTV decoder) using the INPUT 3
S-VIDEO and INPUT 4 VIDEO terminals
E-13
1 Connect one end of the S-video cable (commercially
available) to the INPUT 3 S-VIDEO terminal, or one end
of the video cable (commercially available) to the INPUT
4 VIDEO terminal on the projector.
2 Connect the other end of the S-video cable or the video
cable to the S-video output or Video output terminal of
the video source.
The S-video input terminal uses a video signal system where
the picture is separated into a color and luminance signal
to realize a higher-quality image.
• For higher quality video, you may use the S-video input terminal on the
projector. S-video cable is commercially available.
• If your video equipment does not have an S-video output terminal, use
the composite video output terminal.
Power cord
CACCU5013DE01