Troubleshooting - Daikin Siesta ATXC20BV1B Operating Manual

TROUBLESHOOTING

For any enquiries on spare part please contact your authorized dealer. If any
malfunction of the air conditioner unit is noted, immediately switch off the power
supply to the unit. Check the following fault conditions and causes for some
simple troubleshooting tips.
1. The compressor does not operate 3
minutes after the air conditioner unit is
started.
2. The air conditioner unit does not operate.
3. The air flow is too low.
4. Discharge air flow has bad odour.
5. Condensation on the front air grille of the
indoor unit.
6. Water flowing out from the air conditioner
unit.
If the fault persists, please call your local dealer / serviceman.
Fault Causes / Action
– Protection against frequent starting. Wait for
3 to 4 minutes for the compressor to start
operating.
– Power failure, or the fuse need to be
replaced.
– The power plug is disconnected.
– It is possible that your delay timer has been
set incorrectly.
– If the fault persist after all these verifications,
please contact the air conditioner unit
installer.
– The air filter is dirty.
– The doors or windows are open.
– The air suction and discharge are clogged.
– The regulated temperature is not high
enough.
– Odours may be caused by cigarettes, smoke
particles, perfume etc. which might have
adhered onto the coil.
– This is caused by air humidity after an
extended long period of operation.
– The set temperature is too low, increase the
temperature setting and operate the unit at
high fan speed.
– Switch off unit and call dealer.
1-28