Table of Contents
Advertisement
System Overview
Front Panel
1.
LCD Display: Allows network administrator to check important system settings such as network interface,
SZ configurations, etc.
2.
Navigation Buttons: Use the Esc, Up, Down, and Enter buttons for navigation on the LCD display.
3.
Reset:
Press and hold the Reset button for about 5 seconds and status of LED on front panel will start to
blink before restarting the system.
Press and hold the Reset button for more than 10 seconds and status of LED on the front panel will
start to speed up blinking before resetting the system to default configuration.
4.
LED Indicators: There are three kinds of LED, Status, Hard disk and Power, to indicate different status
of the system.
Console/USB: The administrator can use a terminal emulation program such as Microsoft's Hyper
5.
Terminal to login to the configuration console interface to change admin password or monitor system
status, etc. The USB Port is reserved for future use.
6.
WAN1/ WAN2: Two WAN ports (10/100/1000 Base-T RJ-45) are connected to the external network, such
as the ADSL Router from your ISP (Internet Service Provider).
7.
LAN1~ LAN4: Client machines connect to WHG525 via LAN ports (10/100/1000 Base-T RJ-45).
Rear Panel
1.
Device Cooling Fan: Don't block the cooling fans. Leave enough open space for ventilation.
2.
VGA Connector: Reserved for future use.
3.
USB: Reserved for future use.
4.
Power Supply Socket: Connecting the power cord to the built-in open-frame power supply (Input:
100~240 VAC, 50/60 Hz ).
WHG525
Secure WLAN Controller
②
Quick Installation Guide
ENGLISH
Advertisement
Table of Contents
