Adding/Removing Laundry In Standby Mode; Childproof Lock - Beko DC 7130 User Manual

C
Press "Start/Pause/Cancel"
button for 3 seconds to cancel the
programme or turn the programme
selection knob in any direction
to end the programme while the
machine is running. Water tank
and filter cleaning warning lights
turn on to warn the user when
the programme is cancelled by
pressing the "Start/Pause/Cancel"
button for 3 seconds. However, the
warning lights do not turn on when
the programme is cancelled by
turning the programme selection
knob. Only the drying light turns on
and the machine remains in hold
until a new programme is selected
and the "Start/Pause/Cancel"
button is pressed. Child-proof
lock of the machine should not be
active in order to perform these
two operations. If the child-proof
lock is active, deactivate it before
performing these operations.
Adding/removing laundry in
standby mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to start
the programme.
C
Any laundry added after the drying
process has started may cause
the dried clothes in the machine
intermingle with wet clothes and
the result will be wet laundry after
the drying process is over.
Dryer / User Manual
C
Laundry may be added or taken
out as much as desired during a
drying process, but this process
will extend the programme
duration and increase energy
consumption since the drying
will be interrupted continuously.
Therefore, it is recommended to
add laundry before the drying
programme has started.
5.12 Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except the
"On/Off" button on the control panel are
deactivated when the child-proof lock is
active.
Press the "Start/Pause/Cancel" and "Cancel
audio warning" buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for 3 sec.
again to deactivate the child-proof lock.
C
Child-proof lock is deactivated
when the machine is restarted by
pressing the On/Off button.
45 / EN