Resetting The Lamp Timer - Sharp XV-Z20000 Operation Manual

Regarding the Lamp (Continued)
5
Insert the new lamp unit.
• Press the lamp unit fi rmly into the lamp
unit compartment. Fasten the securing
screws.
6
Attach the lamp unit cover.
• Close the lamp unit cover in the direc-
tion of the arrow. Then tighten the user
service screws.
Info
• If the lamp unit and lamp unit cover are not
correctly installed, the power will not turn on,
even if the power cord is connected to the
projector.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.
Info
• Make sure to reset the lamp timer only when
replacing the lamp. If you reset the lamp timer
and continue to use the same lamp, this
may cause the lamp to become damaged
or explode.
1
Connect the power cord.
• Plug the power cord into the AC socket
of the projector.
2
Reset the lamp timer.
• While holding down
on the projector, press
projector.
• "LAMP 0000H" is displayed, indicating
that the lamp timer is reset.
-50
Adjustment button
ENTER, and
ON on the
User service screws
ENTER button
AC socket
Securing screws
2
1
Adjustment button
ON button