Operating With The Remote Control; Displaying And Setting The Break Timer; Displaying The Pointer; Using The Spot Function - Sharp XR-30X Operation Manual

Operating with the Remote Control

Displaying and Setting the
Break Timer
1
Press BREAK TIMER.
• The timer starts to count down from 5
minutes.
On-screen display
Press P /R /O /Q to adjust the
2
length of the break time.
• Increases with P or Q
5 minutes s 6 minutes s 60 minutes
• Shortens with O or R
4 minutes s 3 minutes s1 minute
• The break time can be set in units of one
minute (up to 60 minutes).
Canceling the break timer display function
Press BREAK TIMER.
Note
• Break Timer does not function while the pro-
jector is operating the "Auto Sync", "FREEZE"
or "AV MUTE" functions.
32
BREAK TIMER button
POINTER button
SPOT button
Adjustment buttons
(P/R/O/Q)
ECO+QUIET button

Displaying the Pointer

Press POINTER and press P/R/
1
O/Q on the remote control to move
the pointer.
Press POINTER again.
2
• The pointer will disappear.

Using the Spot Function

Press SPOT and press P/R/O/Q
1
on the remote control to move the
spot area.
Press SPOT again.
2
• The spot area will disappear.
Switching the Eco+Quiet
Mode
Press ECO+QUIET on the remote con-
trol or on the projector to switch the
Eco+Quiet mode between on and off.
• When the Eco+Quiet Mode is set to "ON", the
sound of the cooling fan will turn down, the
power consumption will decrease, and the lamp
life will extend.
Note
• Refer to "Lamp Setting" on page
tails of the Eco+Quiet mode.
40 for de-