Beko D1 5062 B Operation Manual page 31

Detergent may have been
put in wet dispenser
drawer.
Detergent may have
gotten damp.
Detergent
Water pressure might be
residue in the
low
dispensing
The detergent in the main
drawer.
wash compartment might
have gotten wet while
taking in the prewash
water..
Detergent might be mixed
with the bleaching agent.
Excessive laundry might
have been loaded in.
There is Wrong program and
detergent left temperature might have
on the laundry. been selected.
Wrong detergent may
have been used.
You may not be using
proper detergent for
automatic washing
machines.
Excessive amount of
detergent may have been
The plug might not be
plugged in the mains outlet. Plug should be checked.
used.
Machine does Too much detergent may
Fuse may have blown.
work. No light have been used for a
Electricity may be cut off.
is on. small amount of lightly
soiled laundry.
The "On/Off" button might
have not been pressed.
Detergent may have been
stored improperly.
The machine
did not start
There is too
Type of material being
after the
much foam.
washed (lace items will
program was
cause excessive foam due
selected and The front door may be ajar.
to their meshed structure).
the 'Start/
Pause/Cancel'
Detergent might have
button was
been put in the wrong
pressed.
compartment.
"Washing"
and "Start/
Pause/Cancel"
Water may have been cut
lights are
off.
Softener being released
flashing after
early.
the program is
started.
It shows the safety period
The "Lid" light is
until the door lock is
flashing.
opened.
Dry the detergent drawer before putting in
detergent.
Store detergent in a closed and dry place. Do
not keep them under high temperatures.
The detergent dispenser outlet (holes) may
have a problem.
There might be problems with the detergent
dispenser valves.
Softener should not come into contact with
detergent when being added.
Do not load the machine in excess.
Select the proper program and temperature
for the laundry to be washed.
Use wool detergents for woolens.
Use only automatic washing machine
detergents in your washing machine.
Use only sufficient amount of detergent.
Fuse should be checked.
Use only sufficient amount of detergent.
Power should be checked.
This button must be pressed.
Store detergent in a closed and dry location.
Do not store in excessively hot places.
Use smaller amounts of detergent for lace
items.
If you put detergent in the prewash
compartment although you have not selected
a prewash cycle, the machine can take this
detergent during rinsing or softener step.
You can restart your machine by pressing
You may have added too much softener.
the "Start/Pause/Cancel" button for a short
The detergent dispenser might be
time after ensuring that the water is not cut
problematic. Water may be siphoned (pulling
off.
the softener into the washer early) during the
fill or rinse cycles.
There might be problems with the valves.
For your safety, the front door can only
be opened 2 minutes after the program is
completed. The "Lid" light will flash during
this period.
31
EN