Connecting To A Monitor; Using As A Wired Remote Control - Sharp XG-C60X Operation Manual

Connecting to a Monitor

Watching Images on
Both the Projector and
a Monitor
You can display computer images on both the
projector and a separate monitor using two
sets of an RGB cable. An RGB cable is sup-
plied with this projector. You need to buy an-
other RGB cable for connecting the projector
to a monitor.
1
Connect the projector to the
computer and monitor using
RGB cables (one is supplied, the
other is commercially available).
2
In the "Options(1)" menu, se-
lect "Economy Mode", "Mntr.
out/RS232" and then "ON".
(see page 69.)
Note
• Analog RGB signals as well as Component
signals can be output to the monitor.

Using as a Wired Remote Control

Connecting the Remote
Control to the Projector
When the remote control cannot be used due to
the range or positioning of the projector (rear pro-
jection, etc.), connect a ø3.5 mm stereo or mono
minijack cable (commercially available or available
as Sharp service part QCNWGA038WJPZ) from the
WIRED R/C JACK on the top of the remote control
to the WIRED REMOTE control input terminal.
Note
• FORWARD/BACK presentation control can-
not be used when the remote control is wired
to the projector. To utilize this feature, dis-
connect the cable from the remote control.
XG-C60X_E_PDF_p19_24.p65 23
Supplied
accessory
To RGB input terminal
Optional
cable
RGB cable
(commercially available)
RGB cable
(supplied)
WIRED REMOTE control input terminal
03.9.14, 4:16 PM
RGB cable
Monitor
Desktop computer
To RGB output terminal
To WIRED R/C JACK
ø3.5 mm stereo or mono
minijack cable
(commercially available or
available as Sharp service
part QCNWGA038WJPZ)
-23