Philips 220B4LPCS/00 Service Manual page 71

4.5Vertical scanning
Sync polarity
Scanning frequency
4.6Power input connection
Power cord length
Power cord type
4.7Power management
The monitor must comply with the Microsoft On Now specification, and meet EPA requirements.
The monitor must comply with the Microsoft On Now specification, and meet EPA requirements.
Mode
Power-On
Standby
power Saving
DC Power Off
AC SW Off
Note 1 : a. D-SUB mode,
Normal node to Power saving mode: 15/s (typ.) 18/s
Power saving mode to Normal: 4/s(typ.)
b. DVI mode,
Normal node to Power saving mode: 15/s(typ.) 18/s max
Power saving mode to Normal: 4s(typ.)
c. DP mode,
Normal node to Power saving mode: 15/s(typ.) 18/s max
Power saving mode to Normal: 4s (typ.)
Note 2 : Measurement power Saving.
4.8 VGA Display identification
In accordance with VESA Display Channel Standard Ver.1.0 and DDC 2B capability
4.9 DVI Display identification
In accordance with DVI requirement (DDWG digital Visual Interface revision 1.0)
use DDC-2B, DDC/CI, and EDID V1.3
4.10 DP Display identification
4.11 USB support
Connect the upstream port of the monitor to host PC's USB port via USB cable. Then attach
external device to the downstream port of the monitor. Check if the device can work properly.
: Positive or Negative
: 56 - 76 Hz
:1.8M
: 3 leads power cord with protective earth plug.
HSYNC VSYNC Video
On On Active
Off Off Blanked
N/A
Pwr-cons. Indication
< 58W(max.)
White LED
EPA5.0<
31.6W
Blinking white LED
< 0.1xW Typ
Period 3ec on, 3sec off
0.3W (Max)
(In Smile LED)
< 0.1xw
0W
max
Meridian 3
Rec. time
--
Note 1
Note 2
LED Off
LED Off
71