Table of Contents
Advertisement
Adjusting the Height of the Picture
Use the adjuster release to adjust the angle of the projector and height of the picture. Minor adjustments can be
made with the adjusters.
Adjuster
release
Adjusters
1
2
3
Transporting the Projector
Use the carrying handle when carrying the projector.
When transporting the projector, carry it by the handle located on the
side of the unit.
Note:
• Always put on the lens cap to prevent damage to the lens when transporting
the projector.
Caution:
• Do not lift or carry the projector by the lens or the lens cap as this may
damage the lens.
E-13
Adjuster release
Returning the projector to its original position
• While holding the projector with both hands, press the
Notes:
• Adjustable up to approximately 5° from the horizontal.
• When adjustments are made with the adjusters, the picture may
• After adjusting, in some cases, all of the adjuster legs may not be
Cautions:
• Do not press the adjuster release when the adjuster legs are
• When lowering the projector, be careful not to get your fingers caught
• Do not hold the lens when lifting or lowering the projector.
1. Press the adjuster release and lift the
projector to the desired angle with both
hands
• The adjuster legs will extend to the surface of the
table.
2. Remove your hand from the adjuster
release
• The adjuster legs will lock in position. Release the
projector once you are sure the adjuster legs
have locked in position.
3. Make any minor adjustments necessary
• Turn the adjusters to further adjust the angle of
the projector.
adjuster release and slowly lower the projector to its original
position.
become distorted, depending on the relative positions of the
projector and the screen.
resting on the table.
To prevent the projector from wobbling, adjust the adjuster legs so
that they firmly contact the table.
extended without firmly holding the projector.
in the area between the adjusters and the projector.
Carrying handle
Advertisement
Table of Contents
