Network Menu - Sharp AR-C265P User Manual

Network Menu

Note: Factory default settings are shown in bold.
Item
TCP/IP
NETBEUI
IP ADDRESS
SET
IP ADDRESS
SUBNET MASK
GATEWAY
ADDRESS
Factory Default
WEB/IPP
Settings
ENABLE
DISABLE
ENABLE
DISABLE
AUTO
MANUAL
xxx.xxx.xxx.xxx
Default =
198.168.100.100
xxx.xxx.xxx.xxx
Default =
255.255.255.000
xxx.xxx.xxx.xxx
Default =
192.168.100.254
[EXECUTE]
ENABLE
DISABLE
Sharp AR-C265P User's Guide
Explanation
Enables or disables this network
protocol.
Enables or disables this network
protocol.
Change this to Manual to specify the IP
address through the front panel (see
next entry). Required for non-DHCP
networks.
Current assigned IP address. To
change:
• Press ENTER.
+ –
• Use / keys to increment first
octet.
• Press ENTER to move on to the next
octet.
+ –
• Use / keys to increment second
octet.
• Press ENTER to move on to the next
octet.
+ –
• Use / keys to increment third
octet.
• Press ENTER to move on to the last
octet.
+ –
• Use / keys to increment 1st
octet.
• Press ENTER to register the new
address.
Current assigned subnet mask. To
change, proceed as above.
Current assigned gateway address. To
change, proceed as above.
Initializes the network card.
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
107