Chicago Electric 47937 Assembly And Operating Instructions Manual page 10

Note: The cut size may be slightly different from that of the templet. Allow for the distance (Z)
between the router bit and the outside of the Guide Ring (58) by subtracting the bit diameter
size from the Guide Ring (outside diameter), then divide that by 2.
Distance (Z)
The Straight Guide (57) with Guide Shafts (54) is used for chamfer or groove cuts.
(54) (61) (60)
1. Mount the Guide Shafts (54) to the Straight Guide (57) using Screws (60) and Spring
Washers (61). See photo above, left.
2. Loosen the Lock Knobs (31).
3. Insert Guide Shafts into the holes in the router Base (47). See photo above, right.
4. Adjust the Straight Guide to the desired distance from the bit.
5. Tighten Lock Knobs (31).
6. When cutting, move the router with the Straight Guide flat against the side of the
material to be chamfered or grooved.
SKU 47937
Bit
Using the Straight Guide
(54)
(57)
For technical questions, please call 1-800-444-3353.
Guide Ring (58)
Guide Ring Outside Diameter
(47)
(31)
Page 10