Table of Contents
Advertisement
Problem
Air Compressor will
not start.
Low air pressure to
pneumatic tool.
Air pressure too high
to pneumatic tool.
Power Switch not
operating properly.
PLEASE REAd tHE FOLLOWING CAREFuLLY
THe MANUFACTUReR AND/OR DiSTRiBUTOR HAS PROViDeD THe PARTS LiST AND ASSeMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR
DiSTRiBUTOR MAKeS ANY RePReSeNTATiON OR WARRANTY OF ANY KiND TO THe BUYeR THAT
He OR SHe iS qUALiFieD TO MAKe ANY RePAiRS TO THe PRODUCT, OR THAT He OR SHe iS
qUALiFieD TO RePLACe ANY PARTS OF THe PRODUCT. iN FACT, THe MANUFACTUReR AND/OR
DiSTRiBUTOR exPReSSLY STATeS THAT ALL RePAiRS AND PARTS RePLACeMeNTS SHOULD Be
UNDeRTAKeN BY CeRTiFieD AND LiCeNSeD TeCHNiCiANS, AND NOT BY THe BUYeR. THe BUYeR
ASSUMES ALL RISk AND LIAbILITy ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF RePLACeMeNT PARTS THeReTO.
SKU 96496
For technical questions, please call 1-800-444-3353.
tROubLESHOOtING
Possible Causes
1.
No power at outlet.
2.
Cord not connected.
3.
Air Tank maximum air pressure
of 1 PSi has been reached.
Compressor Motor will
automatically shut-off.
1.
Compressor Regulator not properly
adjusted.
1.
Compressor Regulator not properly
adjusted.
1.
Damaged Power Switch.
Probable Solutions
1.
Check power at outlet.
2.
Check that cord is plugged in.
3.
Wait until Air Tank air pressure falls
to 12 PSi. Compressor Motor will
then automatically turn on.
1.
Turn Regulator clockwise to
increase air flow to pneumatic tool.
1.
Turn Regulator counterclockwise to
decrease air flow to pneumatic tool.
1.
immediately disconnect Power
Cord from its electrical outlet.
Do not use Compressor until a
qualified service technician repairs
Power Switch.
Page 12
Advertisement
Table of Contents
