ADURO Single Red Manual page 9

Step 1:
Before starting the treatment, thoroughly cleanse your skin, remove all make-up and any
cosmetics that contain chemical, acidic or reflective components which may affect light
output and provide a decreased or in-effective treatment. Cosmetics that do not contain
this, are recommended to be used during or after treatment for the best possible results.
Step 2:
Use the Aduro facial straps and feed them through the inlet holes located at the sides of the
mask, making sure the velcro can be stuck to the back of the straps.
Step 3:
You are now ready for an Aduro treatment. Put on the facial mask with the light diodes shining
onto the skin. Adjust the straps to secure the Aduro facial mask to the facial area and set to the
desired position.
Step 4:
Selectable modes are chosen via the controller. Simply push the mode button to cycle
through the modes, for the desired treatment(Aduro 7+1).
Step 5:
Turn on the mask and start your full facial rejuvenation experience. Keep the mask on for a total
of up to 20 minutes and remove.
What to expect during an Aduro treatment
Users may feel a warm sensation on the skin, with increased hydration and plumping of the skin
from the first treatment.
After 1 week of treatments:
Most users will expect to notice an improvement in skin texture, with skin appearing more
healthy and skin smoothness.
After 2 week of treatments:
A vast majority of users will expect to see an overall better condition of the skin, when
comparing before the start of treatments.
After 4 week of treatments:
Many users will notice a greater improvement of the skin when compared with before
treatments, with fine lines and wrinkles reduced, acne recovery and overall better healthier
looking skin.
-8-