Craftsman 580.326311 Operator's Manual page 13

120 Volt AC, 20 Amp, Duplex Receptacles
Each duplex receptacle is protected against overload by a
double pole rocker switch circuit breaker.
Use each receptacle to operate 120 Volt AC, single–phase,
60 Hz electrical loads requiring up to 2,400 watts (2.4 kW) at
20 Amps of current. Use cord sets that are rated for 125 Volt
AC loads at 20 Amps (or greater).
Generator Adapter Cord Set
The generator comes with a 25' generator adapter cord set
designed to provide two sets of 120 Volt, 20 Amp outlets
from one 120 Volt, 20 Amp duplex receptacle.
The maximum load on each outlet is 20 Amps. The maximum
total load on both black wire outlets or white stripe wire
outlets is 20 Amps.
NOTE: Follow all safety precautions when connecting any
extension cord or device to the generator.
How to Use the Battery Charger
Use battery charger jack to keep the starting battery charged
and ready for use. Battery charging should be done in a dry
location, such as inside a garage.
1. Plug charger into unit's "12V DC Battery Charger" jack,
which is located on the start switch bracket. Plug battery
charger into a 120 Volt AC wall receptacle.
2. Unplug charger from unit and wall outlet when generator
is being started and while in operation.
3. Keep charger plugged in when generator is not in use to
prolong battery life. The charger has a built in float
equalizer and will not overcharge battery, even when
plugged in for an extended period of time.
IMPORTANT: See Battery Maintenance for additional
information.
13