Becker VC210 Assembly And Operating Instructions Manual page 32

Overwriting the master
To ensure that the new master transmitter is programmed in
the desired radio receiver only, all other receivers which are
connected to the same power supply must be deactivated
from the programming mode. To do so, after switching the
power back on, execute a drive or stop command using the
transmitter for the given receivers.
Overwrite the master transmitter for the lighting system
a) Overwrite the master transmitter by switching on the power
Switch on the power.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The receiver confirms.
► The new master transmitter is now programmed and the old master
transmitter deleted.
b) Overwrite the master transmitter using the programming button
Press the "Lighting system" programming button on the radio receiver for
3 seconds.
► The radio receiver remains in programming mode for 3 minutes.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The receiver confirms.
► The new master transmitter is now programmed and the old master
transmitter deleted.
32 - en