Lightspeed Flexmike Daily Operation Instructions page 2

DAILY OPERATION
Using the Activate mobile app:
4.
(Refer to the app tutorial for instructions)
Function
Whole Class
Instruction
Small Group
Instruction
Just Listen
Pod to Class
Sharing
Disconnect
Teacher earbud
volume
Recording
Recording audio
source
5. Pod call button:
• Each pod has a call button for students when they need assistance.
• When the button is pressed, a tone sounds in the teacher earbud and the
corresponding pod # will blink on the app.
• The light will continue to blink until the teacher selects that pod.
• To clear multiple blinking lights: press class button.
• If undesirable, this feature can be turned off in the app settings.
6. Return the components to the Activate Station for nightly recharging:
• Place all components in their respective charging slots
• Charging lights will light: red = charging; green = fully charged.
• The units will fully charge overnight.
For complete system operating instructions, go to
www.lightspeed-tek.com/ACT-usermanual
(or scan the 2D barcode).
CON'T
Command Description
Press class Activates classroom speaker to distribute
button teacher's voice to the entire room.
Press Pod # Connect to each individual student group
pod. The pod # button will light and a tone
will sound in the earbud when connected
(1-2 seconds).
Press MUTE Mute your microphone and move from
pod to pod to monitor (listen only) student
groups, gaining critical insights to the
learning process.
Swipe Pod # to class Allows one student group to address the
button whole class. Both the class and pod # buttons
will turn orange.
Press activated pod Disconnects the transmission and turns any
# again audio off.
Press Vol UP/DOWN Turns the volume to the teacher's earbud up
arrows or down.
Tap the record tab Select video, audio, or photo to capture. Tap
the record button to begin.
Swipe right to reveal Tap the desired audio source: class for
control arc teacher microphone only, or any pod to
capture student group interaction.