Mechanical Inspection - mcmurdo Smartfind G8 AIS User Manual

WARNING – While the EPIRB is running this self-test it cannot generate a
distress alert. It is therefore recommended that this self-test is performed
only under conditions where an emergency is unlikely to arise.
If necessary, the self-test may be terminated at any time by holding down the
TEST button for 10 seconds.
7.3

Mechanical inspection

It is recommended that a monthly check is carried out to inspect the EPIRB
and its mountings visually for deterioration or damage.
On the EPIRB itself check the following:

Inspect the EPIRB for any obvious damage

Check that the lanyard is not tied to the vessel structure

Check the battery is within its expiry date

Check that the sea contacts are clean and free from paint or grease

Check that the antenna has not been damaged or creased and that it
erects to a vertical position when released.

Check that the beacon is stored such that no pressure can be applied
to the TEST button, and that the covers on the ON and OFF buttons are
closed to ensure the beacon cannot be activated inadvertently.
If you have a manual bracket:

Check the EPIRB is correctly fitted and is secure in its bracket

Check that the two halves of the bracket are securely clipped together
If you have a float-free enclosure:

Check the HRU is within its expiry date

Confirm the cover can be easily removed

Ensure the EPIRB base is correctly fitted into the D-shaped recess and
that the antenna is correctly stowed
If the EPIRB or its mounting needs cleaning, then this should be done using
warm soapy water and a damp (not wet) cloth. Do not use strong detergents or
solvents.
Due to the impact of the marine environment on vessel equipment stored or
regularly exposed to often harsh climate conditions, McMurdo strongly
recommends owners obtain a five- year external health check at an authorised
McMurdo Service Centre. Locations of authorised service dealers can be
found at
WARNING – Do not paint the EPIRB or its mounting. Do not clean with
detergents or solvents. It is recommended that the EPIRB and its
mounting are removed during vessel cleansing or painting operations.
www.mcmurdogroup.com .
Page 27