1. Manuals
  2. Brands
  3. Waterstone Manuals
  4. Plumbing Product
  5. 4100-12
  6. Installation instructions manual

Waterstone 4100-12 Installation Instructions Manual

Traditional kitchen and prep faucet
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
TRADITIONAL KITCHEN AND
PREP FAUCET INSTALLATION
INSTRUCTIONS
4100-12
4100-18
4700
Kitchen Model #s:
4100-12
4100-18
4200
4300
Prep Model #s:
4700
4800
4900
4200
4300
4800
4900

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4100-12 and is the answer not in the manual?

Questions and answers

Related Manuals for Waterstone 4100-12

Summary of Contents for Waterstone 4100-12

  • Page 1 TRADITIONAL KITCHEN AND Kitchen Model #s: 4100-12 4100-18 PREP FAUCET INSTALLATION 4200 4300 INSTRUCTIONS Prep Model #s: 4700 4800 4900 4100-12 4100-18 4200 4300 4700 4800 4900...

  • Page 2: Faucet Installation

    Channel Locks HANDLE POSITION Waterstone faucets are designed to be installed in 3 different faucet positions. Choose to have the handle on left, front or right. Your faucet is factory configured for the most common positions - a front and right side installation.
  • Page 3 5. To adjust handle tension, turn ring (F) clockwise to increase or counterclockwise or right (Fig. 1). Waterstone gives you the option of adjusting to decrease handle tension. the handle 45 degrees to avoid hitting backsplash.
  • Page 4 CLEANING AERATOR AND DEBRIS SCREEN Depending on quality of your household water, the aerator and 1. Gently unscrew and remove spout tip (A) by hand. debris screen may become clogged. We recommend cleaning 2. Remove O-ring (B). To remove aerator (C), push with finger from bottom. one week after installation, then a minimum of once of year 3.
  • Page 5 INSTALL OPTIONAL SOAP/LOTION DISPENSER 1-3/8” HOLE Pull and remove spout (A) from dispenser body (B). Remove COUNTER clamp nut (C) from OR SINK threaded shroud (D). Fit dispenser body through 1-3/8” hole on counter or sink. (No plumbers putty is required.
  • Page 6 CONTINUED FROM PREVIOUS PAGE GARBAGE DISPOSAL Slide other end of tubing (F) into tube Plug control box into undersink fitting at bottom of Tighten clamp screws (E) Hand tighten switch base back electrical outlet. Plug garbage securely with screwdriver. down to cover threads. control box (G).
  • Page 7 INSTALL DUAL PORT AIR GAP (OPTIONAL) 1-1/2” HOLE Slide gasket down and screw Pull air gap (A) off of upper cap Unscrew and remove top clamp From underneath counter top clamp nut back onto piping. Adjust the two clamp nuts to nut (B).

This manual is also suitable for:

4100-1842004700480049004300

Table of Contents