Table of Contents
Advertisement
3.7 DC Wire Connection
10' long Control
Switch Wires
3.8 Control Switch
•
Mount the control switch near where the cable exits
the side of the boat.
•
Connect red quick connector terminal to the tabs on
the control switch.
6
DC Power Input
• 12 or 24v DC Input (check
label on unit)
RED - DC Positive +
BLACK - DC Negative
• use 15amp breaker or fuse
The Cordreel comes with (2) 14 gauge wires exiting from
the gear motor cover.
•
These wires should be connected to the 12 or 24
VDC power source depending on unit purchased
(see label on unit for correct voltage).
•
Connect wire to DC battery as shown to left.
•
Make sure all connections are secured and protect-
ed from the environment.
!
WARNING:
•
All wiring should be done in ac-
cordance with ABYC's standards. If
you are unsure of these standards,
consult a qualified electrician.
Cutout for switch is
1" x 1.75"
!
Advertisement
Table of Contents
