3.2 Installation Configurations
The Cordreel(16, 30, and 32) is capable of being mounted in multiple configurations:
Deck Mounting –standard
(as shipped configuration)
Overhead Mounting - standard
3.3 Mounting Instructions
•
In general, the Cordreel will be mounted to either the floor or the overhead of the compartment where it will be
located.
•
Allow clearance for the Cordreel storage spool to operate freely without obstruction or interference, and for the
connection of the power cable from your power supply.
•
Install the Cordreel using 1/4" bolts, 1" long minimum. Bolt unit in each of the four corners. (See above for
bolting locations. Look for
•
In general, the Cordreel will be mounted to either the floor or the overhead of the compartment where it will be
located.
NOTE: Unspooling the power cord before mounting the Cordreel can aid installation in tight spaces.
NOTE: There is also an optional baseplate that can be used for overhead mounting. (Use 6 bolts to mount baseplate.)
Optional Base Plate
Part# 60537. Mount
using 6 bolts.
Note: Baseplate is not
required for overhead
mounting.
Guide Roller Assembly
can be moved from top
position to bottom
position. Remove 4
bolts/spacers, move
assembly and re-install
including 4 spacers.
)
Deck Mounting – reverse
(similar to original CRM30 config.)
Overhead Mounting - reverse
3