2.0 P RODUCT IMENSIONS CRMA 16/30/32 3.0 C ORDREEL NSTALATION 3.1 Before You Start the Installation The most important part of your installation is planning the best layout for the shore power cable routing from the unit to where it exits the boat (normally through a Hawse Pipe). Be sure that cable is routing a straight path, free from any obstacles.
3.2 Installation Configurations The Cordreel(16, 30, and 32) is capable of being mounted in multiple configurations: Deck Mounting – reverse Deck Mounting –standard (similar to original CRM30 config.) (as shipped configuration) Overhead Mounting - standard Overhead Mounting - reverse Optional Base Plate Part# 60537.
Page 5
3.5 Installing the Hawse Pipe (optional accessory) The installation of the Hawse Pipe is optional. Part# 04049-CRM Hawse Pipe Assembly You may also use an existing hatch or any storage space door that is accessible to where you want the Hole cut out 3.75”...
3.7 DC Wire Connection The Cordreel comes with (2) 14 gauge wires exiting from the gear motor cover. • These wires should be connected to the 12 or 24 VDC power source depending on unit purchased (see label on unit for correct voltage). •...
4.0 O PERATING NSTRUCTIONS To operate your Cordreel: • PULL OUT only the amount of shore power cord required to reach the outside power source. • CONNECT your shore power cord to outside power source receptacle. • TURN ON outside power supply. When ready to get underway: CAUTION: •...
PRODUCT COVERED BY THIS LIMITED WARRANTY: CRMA 16/30/32 1. GLENDINNING PRODUCTS, LLC. warrants to the original consumer purchaser that the CRMA 16/30/32 will be free from defects in material and workmanship under normal use and service for a period of one (1) year from the date of purchase.