Flex FHE 2-22 SDS-plus Original Operating Instructions page 16

 Insert insertion tool (1.) and turn (2.)
it until it locks.
 Check lock by pulling on the insertion tool.
Removing the tools
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
CAUTION!
Used insertion tools may become hot.
Wear protective gloves!
 Pull locking sleeve backwards (1.).
 Remove insertion tool (2.).
Setting operating mode
CAUTION!
Do not change operating mode until
the electric power tool is at a standstill.
 Press release button.
16
 Setting rotary knob to the required
operating mode:
Drilling
Hammer drilling
NOTE!
The release button must visibly lock
(jump out) in the
(hammer drilling) positions.
Setting direction of rotation
CAUTION!
Do not change operating mode until
the electric power tool is at a standstill.
 Set switch for selecting direction
of rotation to the required position:
– L counter-clockwise
– R Clockwise
Switching on the power tool
Without locking the switch:
 Press and hold down the switch.
The electric power tool switch enables
the speed or impact rate to be increased
slowly to the maximum value.
Switch off the machine:
 Release the switch.
FHE 2-22
(drilling) and