Advertisement
902-762 Four Panel Circular Aztec Climber
STEP #2:
Place all posts in their proper locations.
panel to the short welded frame, paying close attention to the
dragon/snake figure (see image).
a bolt cap and then through the Aztec panel and tabs on the frame
and out the back side of the panel.
washer over the bolt and hand tighten nut (see bolt configuration
image).
STEP #3:
Brace that frame (bracing example can be found on page 2 of these
instructions) and connect that panel to the bent vertical post
following the same bolt configuration in the previous steps.
STEP #4:
Repeat steps 2 and 3 using all illustrations as a
guide for the remaining posts and panels.
STEP #5:
Plumb & level entire unit. Fully snug all fasteners. Push bolt
caps in to bolt covers. Pour Concrete with slight dome to ensure
proper drainage.
resilient safety surfacing.
STEP #6:
Attach Warning Label and Manufacturer's Identification Label to a
clean surface.
they are clearly visible and legible and away from normal hand
SportsPlay Equipment, Inc., 5642 Natural Bridge, St. Louis, MO 63120 (314) 389-4140
Designed for Ages 5-12
Install hardware in all three holes on that panel.
Panel Attachment Illustration
Washer
Not pictured
– bolt cover
Post Tab
Wait 48 hours before removing braces. Install
The Labels should be attached in a location where
www.sportsplayinc.com
Attach a plastic
Place a bolt and washer through
Then slide another cap and
Nut
Bolt Cover
Bolt Configuration Image
6
Page
Rev. 04/9/2010
Aztec Panel
Flat Washer
M10 Bolt
Bolt cover Cap
Advertisement
