China Postal Code; Enable/Disable China Postal Code; Checksum Verification - Inateck BCST-33 User Manual

3.15. China Postal Code

3.15.1. Enable/Disable China Postal Code

Decide whether to enable China Postal Code by scanning correspondent barcode
below. Inateck BCST-33 defaults to "Disable China Postal Code".
Enable China Postal Code
(*)Disable China Postal Code

3.15.2. Checksum Verification

Checksum character is not enforced to be included in the data of China Postal Code.
If checksum character is included, it should be the last character of the barcode data.
As a calculate value based on all of the data, Checksum character is used to check
whether the data is correct or not.
If the scanner is set to "Do Not Verify", which is the default, then the scanner will read
all the barcode data.
If the scanner is set to "Verify with Output Checksum Character", and the scanner will
check the data based on the last character of the barcode data. If the check passes,
the scanner will read and output the Checksum Character as the last character of
normal data; However the scanner will not be able to read China Postal Code without
checksum character under this setting.
If the scanner is set to "Verify without Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check
passes, the scanner will read but will NOT output the Checksum Character; However
the scanner will not be able to read China Postal Code without checksum character
under this setting.
(*)Do Not Verify
Verify with Output Checksum Character
Verify without Output Checksum Character
50