Iata 2 Of; Enable/ Disable Iata; Checksum Verification - Inateck BCST-33 User Manual

3.11. IATA 2 of 5

3.11.1. Enable/ Disable IATA 25

Decide whether to enable IATA 25 by scanning correspondent barcode below.
,Inateck BCST-33 defaults "Disable IATA 25".
Enable IATA 25
(*)Disable IATA 25

3.11.2. Checksum Verification

Checksum character is not enforced to be included in the IATA 25 data. If checksum
character is included, it should be the last character of the barcode data. As a
calculate value bases on all the data, Checksum character is used to check if the data
is correct or not.
Thus, if the scanner is set to "Do Not Verify", which is default, then the scanner will
read and output all the barcode data.
If the scanner is set to "Verify with Output Checksum Character", and the scanner will
check the data based on the last character of the barcode data. If the check passes,
Inateck 0CST-33 will read and output the Checksum Character as the last character of
normal data; However, it will not be able to read IATA 25 without checksum character.
If the scanner is set to "Verify without Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check
passes,
Inateck BCST-33 will read but will NOT output the Checksum Character as the
last character of normal data; However it will not be able to read IATA 25 without
checksum character.
(*)Do Not Verify IATA 25
Verify with Output Checksum Character
Verify without Output Checksum Character
46