Standard 2 Of 5 / Industrial 2 Of; Enable / Disable Standard; Checksum Verification - Inateck BCST-33 User Manual

3.14. Standard 2 of 5 / Industrial 2 of 5

Standard 2 of 5 is also known as Industrial 2 of 5.

3.14.1. Enable / Disable Standard 25

Decide whether to enable Standard 25 by scanning correspondent barcode below.
Inateck BCST-33 defaults to "Disable Standard 25".
Enable Standard 25
(*)Disable Standard 25

3.14.2. Checksum Verification

Checksum character is not enforced to be included in the data of Standard 25. If
checksum character is included, it should be the last character of the barcode data. As
a calculate value based on all the data, Checksum character is used to check whether
the data is correct or not.
If the scanner is set to "Do Not Verify", which is the default, then the scanner will read
all the barcode data.
If the scanner is set to "Verify with Output Checksum Character", and the scanner will
check the data based on the last character of the barcode data. If the check passes,
the scanner will read and output the Checksum Character as the last character of
normal data; However the scanner will not be able to read Standard 25 without
checksum character under this setting.
If the scanner is set to "Verify without Output Checksum Character", and the scanner
will check the data based on the last character of the barcode data. If the check
passes, the scanner will read but will NOT output the Checksum Character; However
the scanner will not be able to read Standard 25 without checksum character under
this setting.
(*)Do Not Verify
Verify with Output Checksum Character
Verify without Output Checksum
Character
49