Wiener CC-USB User Manual page 14

Yellow LED and NIM O3
14 13
Latch Invert
The 3-bit code identifies the source of the signal. The sources differ for different LEDs and
NIM outputs, but they are the same between the LED and NIM targets (i.e., Red LED has the
same sources as the NIM output O1, Green LED the same as O2, and Yellow LED the same
as O3) For firmware 4503, the sources are as follows:
Code Red LED
0 Event Trigger
1 Busy
2 USB Trigger
3 USB Out FIFO not empty
4 USB In FIFO not full
5 Reserved
6 Acquire
7 Camac F2
Code NIM O1
0 Busy
1 Event Trigger
2 USB Trigger
3 USB Out FIFO not empty
4 USB In FIFO not full
5 Reserved
6 Acquire
7 Camac F2
WIENER, Plein & Baus GmbH
Green LED and NIM O2
10-12 9
Code Latch Invert
Green LED
Acquire
Camac F1
Reserved
Event Trigger
Data Buffer Full
Reserved
NIM I1
USB In FIFO not empty USB Trigger
NIM O2
Event Trigger
Camac F1
Reserved
Event Trigger
Data Buffer Full
Reserved
NIM I1
USB In FIFO not empty USB Trigger
8 5-7
Code Latch
14
Red LED and NIM O1
4 3 0-2
Invert Code
Yellow LED
NIM I3
Busy
NIM I2
Camac S1
Camac S2
USB In FIFO not empty
Executing scaler stack
NIM O3
EndOfBusy
Busy
NIM I2
Camac S1
Camac S2
USB In FIFO not empty
Executing scaler stack
www.wiener-d.com