Table of Contents
Advertisement
Error Messages
ERROR MESSAGES
BATT EMPTY
The battery is run down.
(LoBATT)
BLANK MD
Nothing is recorded.
(BLANK)
Can't COPY
You tried to record from a copy prohib-
(Can'tC)
ited MiniDisc.
Can't EDIT
A track cannot be edited.
(Can'tE)
Can't READ *
The disc data cannot be read because the
(Can'tS)
disc is damaged.
(Can'tT)
(Can'tU)
Can't REC
Recording cannot be performed correctly
(Can'tR)
due to vibration or shock.
Can't STAMP
Stamp function does not work.
Can't WRITE
Cannot save the TOC information correctly
(Can'tW)
to a MiniDisc. (A large portion of the disc
has been damaged.)
CHARGEmode
The Charge/Operation switch is not set to
the operation mode when using this unit
with the AC adaptor.
DEFECT
The disc is scratched.
(DEFECT)
DISC FULL
The disc is out of recording space.
Er-MD **
The microprocessor has reported a sys-
(ErMD*)
tem fault and the unit is out of order.
HOLD
The unit is in the hold mode.
(HOLD)
LOCKED
You removed a MiniDisc whilst recording
(Can'tLOCK)
or editing.
54
Web-site: www.sharp.co.uk/support
MEANING
Charge the rechargeable battery or replace the alkaline bat-
tery (or use the AC adaptor for power).
Replace the disc with a recorded disc.
Record using the analogue cable.
Change the stop position of the track and then edit it.
Reload the disc.
Replace it with another recorded disc.
Re-record or replace it with another recordable disc.
Check the number of tracks.
Replace the disc with another recordable disc.
Set the Charge/Operation switch to the operation mode.
If the sound you hear is not right, record again.
Replace the disc with another recordable disc.
Replace it with another recordable disc.
To have it repaired, go to the distributor where you purchased
the unit.
Return the HOLD switch to its original position.
Turn off the power and remove the MiniDisc.
Help Line: 08705 274277 (office hours)
REMEDY
Advertisement
Table of Contents
Troubleshooting
