Table of Contents
Advertisement
Error Messages : continued
ERROR MESSAGES
MEANING
NO DISC
A disc has not been loaded.
NO SIGNAL
Poor connection of the digital cable.
(noSIG.)
No output signal comes out from the con-
nected unit to playback.
The input signal has improper sampling
frequency.
PLAY MD
You recorded on a playback-only disc.
(PLAYmd)
POWER ?
The battery charger is defective.
PROTECTED
The write protection tab of a MiniDisc is
set to the protected position.
You tried to record on a playback-only disc.
SORRY
Since a track number is currently being
(Sorry)
located or updated, the unit cannot accept
your command.
TEMP OVER
The temperature is too high.
(TEMP!)
TOC FORM **
There is an error in the recording signal.
(Tform**)
TOC FULL
There is no space left for recording char-
acter information (track names, disc
names, etc.).
Tr. Protect
The track has been protected from being
erased.
? DISC
A disc which contains data other than
(? DISC)
music was played.
There is an error in the signal recorded
on the disc.
Stamping is not possible.
(
) : Error messages seen on the remote control.
Number or symbol appears in * position.
Load a disc.
Connect the digital cable securely.
If the portable CD player has a function to prevent sound skips,
deactivate it.
Playback with the connected unit.
Replace it with a recordable disc.
To have it repaired, go to the distributor where you purchased
the unit.
Move the write protection tab back to its original position.
Replace it with a recordable MiniDisc.
Wait for a while and try the operation again.
Turn off the power, and wait for a while.
Erase all of the tracks, and then record again.
Replace it with another recordable disc.
Edit the track with the device on which it was recorded.
A disc which contains non-music data cannot be played.
Replace it with another recorded disc.
Retry.
Web-site: www.sharp.co.uk/support
REMEDY
Help Line: 08705 274277 (office hours)
55
Advertisement
Table of Contents
Troubleshooting
