Replace Door Seal; Replace Water Valve; Replace Fill Tube; Replace Heater - Electrolux FDR251RJR0 Service Manual

5. To remove bracket, remove screw mounting bracket
to bottom of tub.
6. To reassemble float switch and bracket, reverse
order.

Replace Door Seal

1. Open door and pull seal from mounting channel in
tub.
2. Check new seal for center marking on backside of
seal.
3. Find center of seal and start at door strike. Insert
seal into channel.
4. Go to bottom of either side and start seal into
bottom, then push seal into channel at 5 to 6 spots
up that side.
5. Go to other side and repeat step 4.
6. Close door to set seal.

Replace Water Valve

1. Disconnect dishwasher from electrical supply.
2. Turn off water supply to water valve from water
source.
3. Remove access panel. (See Remove Access
Panel.)
4. Disconnect water line from water valve. Be careful
to catch water when removing water line from valve.
5. Remove tub fill tube from valve.
6. Remove mounting screws.
7. Remove wiring harness connector.
8. Install new water valve . Reverse procedure to
complete repair.

Replace Fill Tube

1. Disconnect dishwasher from electrical supply.
2. Remove access panel. (See Remove Access
Panel.)
3. Check water line, drain line and electric line for slack
to slide dishwasher from under counter.
4. Remove tube from back of valve by expanding
clamp.
5. Remove two screws mounting dishwasher to
countertop.
6. Slide dishwasher forward to gain access to water
inlet to tub and remove clamp.
7. Install new tube in reverse procedure to complete
repair.
NOTE: When
reinstalling new filll
tube, be sure the
tube is mounted
into retainers on
side of tub.

Replace Heater

1. Disconnect dishwasher from electrical supply
2. Remove access panel (see Remove Access Panel).
3. Remove wire connections from terminals on heater.
4. Remove nuts holding heater to bottom of tub.
5. DO NOT REMOVE RETAINER CLIPS FROM TUB.
6. From inside of tub, lift heater into tub and slide
heater out of retainer clips.
7. Install new heater in reverse procedure to complete
repair.
8. After reassembly, be sure to check for water leaks.
13