Service And Repair Disassembly; Safety Precautions; Remove Outer Door Panel; Remove Control Panel - Electrolux FDR251RJR0 Service Manual

SERVICE AND REPAIR DISASSEMBLY

SAFETY PRECAUTIONS

Always turn off the electric power supply before servicing
any electrical component, making ohmmeter checks,
or replacing any part.
All voltage checks should be made with a voltmeter
having a full scale range of 130 volts or higher.
After service is completed, be sure all safety grounding
circuits are complete, all electrical connections are
secure, and all access panels are in place.

Remove Outer Door Panel

1. Disconnect dishwasher from electrical supply.
2. Open door and remove two bottom screws from
both sides of outer door panel. Hold panel as
screws are removed. See figure below.
3. Close door and pull bottom of outer door panel
away from door as you pull down on outer door
panel.

Remove Control Panel

1. Disconnect dishwasher from electrical supply.
2. Open door and remove six screws around control
panel. See figure below.
3. Close door and pull control panel away from top of
door and up. Be sure control panel clears door latch.
Control Panel can be removed without removing outer
door panel. Be sure to use caution not to scratch outer
door panel.
Door Panel
Screws
Control Panel
Screws

To Replace Timer:

1. Disconnect dishwasher from electrical supply.
2. Remove timer knob. Note: You may need to add
two pieces of tape to the sides of the knob and use
pliers to remove the knob.
3. Remove six (6) screws securing control panel to
inner door panel. (See Remove Control Panel .)
4. Carefully pull console forward to gain access to
the controls.
5. Remove one (1) screw securing timer to control
panel. With screw removed, lift locking tab just
above mounting screw and slide timer to left and
lift timer from control panel.
Screw Hole
Lock Tab
6. Lift the locking tab and pull multiconnector from
timer. See figure below.
7. To install new timer, reinstall multiconnector onto
new timer. Line up mounting tabs on right side of
timer, as well as under locking tab into slots in
control panel. Slide timer to right until lock tab on
timer falls over post on control panel, then install
mounting screw.
8. Reinstall control panel and knob. Check operation.
Door Panel
Screws
11
Lock Tab