Operation Of Remote Control - Sharp 32N-S500 Operation Manual

Operation of Remote Control

L Universal Remote Control
With the purchase of your television set you also have received
the latest innovation in remote control technology. With its easy-
to-use push button keyboard, your Remote can control your
television set and most infrared remote controlled VCRs and
cable TV converters as well.
NOTE:
• Depending on the model, year produced, brand and type of VCR,
some models may not be compatible with the remote control.
• Some brands of Cable TV converter Box may not enable channel
selection until the ENTER is pressed.
Example:
When you select channel 24,
(1) Press REMOTE KEYPAD "2".
(2) Press REMOTE KEYPAD "4".
(3) Press ENTER .
For detailed information on the use of the VCR or Cable TV
converter Box refer to their operating manuals.
L Using Your Remote With Your TV
After installing the batteries, set the TV-CATV on the remote to
the TV position. (If you can change the channel of the TV by
pressing CH UP ( 8 ) or DOWN ( 9 ) on the Remote Control, it is
the TV position.)
VCR POWER
Press to turn the VCR on and off.
PLAY -
Press to playback a tape.
REWIND (
Press to rewind a tape.
For some VCRs you may need to
press STOP first, then REWIND.
In Playback mode, hold button
down to view picture moving rapidly
in reverse.
PAUSE J
Press to temporarily stop the tape
during playback or recording.
Press again to release Pause.
STOP L
Press to stop the tape.
L "Identifying" Remote VCR and Cable TV Converters
Your Remote Control has been set at the factory to operate your
TV and many remote control VCRs and Cable Converters.
However, in some cases an easy one-time set-up step may be
necessary before the Remote will operate accessory VCRs and
Cable Converters.
• In this set-up step, the Remote locates and memorizes the remote
control transmitter code for the VCR or Cable Converter.
• Once "identified", the Remote sends the proper remote signals
to operate your accessory.
• This identify step will not have to be repeated until power to the
Remote is interrupted due to a battery failure.
L USING YOUR REMOTE CONTROL WITH A VCR
Once you make certain the Remote Control has "identified" your
remote controlled VCR, the Remote Control is ready to operate
your unit. The various VCR function buttons on the Remote
Control will not operate your VCR if those features are not already
found on your unit.
• All VCR buttons will operate whether the Remote Control is in
TV or CATV modes.
• For detailed information on the use of the VCR, refer to the
operation manual of the VCR.
POWER
TV
VCR INPUT
1 2 3
4 5 6
7 8 9
FLASHBACK ENTER
0 100
PERSONAL PREFERENCE
A B C D
CH
VOL VOL
— +
CH
MENU
CATV TV
REW PLAY FF
VCR CH
PAUSE STOP REC
PIP CM SKIP DISPLAY MUTE
SWAP FREEZE MOVE SELECT
TV • VCR • CATV
REMOTE KEYPAD
Use to enter two-digit code numbers
when identifying your VCR.
ENTER
FF )
Press to rapidly advance the tape.
For some VCRs, you may need to press
STOP first, then FF.
In Playback mode, hold button down to
view the picture moving rapidly in
forward direction.
VCR CHANNEL
UP (8)/ DOWN (9)
Press to scan up or down through
channels on the VCR.
RECORD [
Press to begin recording.
PIP BUTTONS
See page 24.
27