Using The Video And Audio; Using The Audio Output Jacks - Sharp 25N S100 Operation Manual

Using the Video and Audio Input Jacks (Continued)
L To watch video material playback.
• Press the Remote's INPUT to select VIDEO INPUT mode to which the video equipment you want to
playback is connected.
• The external VIDEO INPUT mode will change as follows each
time the INPUT is pressed.
• INPUT mode can be selected by pressing either the CH UP ( 8 ) on the TV remote control when the
TV is set to the highest channel stored in memory, or by pressing the CH DOWN ( 9 ) when it is set to
the lowest channel.
NOTE:
• When connecting video or audio equipment to the television, be sure that the power is turned off in
order to prevent damage to either the television or the equipment being connected.
• The S-VIDEO terminal has priority over a VIDEO terminal (IN-1). When you want to watch pictures
from video equipment connected to a VIDEO terminal, unplug equipment connected to the
corresponding S-VIDEO terminal.
• It is the intent of SHARP that this product be used in full compliance with the copyright law and that
prior permission be obtained from copyright owners whenever necessary.
• For detailed information on the connection and use of auxiliary equipment, refer to the instruction
manuals of the equipment being used.
• The connection cords can be obtained from your local video store.
Using the Audio Output Jacks (25N-S180 and 27N-S180 only)
L These jacks are used for connecting a standard stereo amplifier. Control of STEREO/MONO/
SAP, VOLUME and MUTE are retained at the TV. These jacks relay the audio signal of all
programs being displayed on the TV screen.
(1) Before connecting the
cord, turn on the TV and
adjust the VOLUME
control on the TV for a
moderate listening level.
(2) Turn off the TV and
connect the audio cord to
the AUDIO LINE OUTPUT
JACKS on the TV.
(3) Turn the TV set and stereo
amplifier on.
(4) If you desire, you can
turn off the sound to the
TV's internal speakers by
SPEAKER mode. See
page 13 - 14.
(5) Adjust the VOLUME
control on the stereo
amplifier for a moderate
listening level.
(6) Control of the audio can be done using the audio controls (STEREO/MONO/SAP, VOLUME, and
MUTE), from either the remote control, or directly from the TV set.
NOTE:
• For detailed information on the connection and use of auxiliary equipment, refer to the operation
manuals of the equipment being used.
• When connecting monaural equipment to the AUDIO INPUT or OUTPUT of this set, use an audio
connection cord and plug adapter as shown below.
• For optimal sound quality, it is recommended to keep the TV's audio output level high.
To the TV
Pin plug x 2
32-40 25&27NS100/180 1.4
(AUDIO OUTPUT JACKS are located on the rear of the cabinet.)
CONNECTIONS
(Rear connection
terminals of TV)
Plug adapter
Pin plug Pin jack/Mini plug
33
To the equipment
being connected
6/1/00, 2:12 PM
33