When Vacuuming - Bushranger BRV2601 Operator's Manual

ASSEMBLY PROCEDURES
When Blowing (continued)
Fitting The Handle
3. Rotate the nozzle tube clockwise locking it into place. (See Fig. 2)
4. Remove the tube locking screw. (See Fig. 3._
Fig. 3
otate the nozzle tube clockwise locking it into place.
emove the tube locking screw.
5. Push the assembled blower tube over the discharge port and locking pin.
locking it into place. 6. Rotate the tube clockwise to lock it into position. (See Fig. 4).
7. Retighten the locking screw.
ush the assembled blower tube over the discharge port and locking

When Vacuuming

n.
1. Unscrew locking wing-nut and store safely until closing the inlet grill. (See Fig. 5).
otate the tube clockwise to lock it into position.
2. Rotate the two vacuum tubes together then open grill and attach onto machine.Rotate tube clockwise into locking
etighten the locking screw.
position (See Fig. 6).
e over the discharge port and locking
n Inhaling
3. Open zupper and pass narrow end of exhale tube through hole at opposite end. Pull narrow end of tube out of hole until
it is held firmly in place at wider end. (See Fig. 7).
nscrew locking wing-nut and store
k it into position.
4. Attach exhale tube to the machine and twist in place then tighten the securing screw. (See Fig. 8).
y until closing the inlet grill
Fig. 5
otate the two inhale tubes together
open grill and attach
store
ine.Rotate tube clockwise
ng position.
gether
onto
en zupper and pass narrow end of
into
e tube through hole at opposite end.
narrow end of tube out of hole until
8
eld firmly in place at wider end.
3. Rotate the nozzle tube clockwise locking it into place.
4. Remove the tube locking screw.
5. Push the assembled blower tube over the discharge port and locking
pin.
6. Rotate the tube clockwise to lock it into position.
7. Retighten the locking screw.
When Inhaling
1. Unscrew locking wing-nut and store
safely until closing the inlet grill
2. Rotate the two inhale tubes together
then open grill and
machine.Rotate tube
locking position.
Fig. 6
3.Open zupper and pass narrow end of
onto
exhale tube through hole at opposite end.
into
Pull narrow end of tube out of hole until
it is held firmly in place at wider end.
Fig. 4
attach onto
clockwise into
Fig. 7
4. Attach exhale tube to the machine
and twist in place then tighten the
securing screw.
Important：
11
Use good quality 4-stroke engine oil.
Use fresh unleaded petrol. Keep fuel out of the reach of children.
Filling the fuel tank
Fig. 8