Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bushranger BRV2600
Summary of Contents for Bushranger BRV2600
- Page 1 OPERATOR’S MANUAL BLOWER VAC BRV2600...
-
Page 2: Table Of Contents
The information contained in this manual describes available at the time of production. While every attempt has been made to give you the very latest information about your BRV2600, there may be some differences between your machine and what is described here. We reserve the right to make changes in production without prior notice, and without obligation to make alterations to machines previously manufactured. -
Page 3: Attention Statements
These procedures are general guidelines only, and are not intended to replace any safely rules/laws that may be in force in your area. If you have any question regarding your BRV2600 blower/vacuum, or if you do not understand something in this manual, your local Bushranger dealer will be glad to assist you. -
Page 4: Specifications
SPECIFICATIONS MODEL BRV2600 DIMENSION 580 X 350 X 370 (L X W X H) ENGINE TYPE 1E34FB CYLINDER DIAMETER 34 mm DISPLACEMENT 26 cc FUEL Gasoline/Oil Mixture 25:1 CARBURETTOR Membrane Type Primer Pump WAY OF IGNITION SPARK PLUG RCJ6Y Recoil Starter... -
Page 5: Assembling The Machine
ASSEMBLING THE MACHINE Ignition Switch Handle Throttle Trigger Cleaner Fuel Blower Tube Starter Fuel Tank... -
Page 6: Mixing Fuel
Vacuum Bag Blower Assembly Instructions • Unzip the bag and place Blower the small end of the • Join the two blower elbow tube through the tubes A & B together. hole at the opposite end. Refer to page 5. Pull the narrow end of the tube out of hole, until it is •... -
Page 7: Starting The Machine
• Never place flammable material close to the WARNING engine muffler. Danger of fire and burn injury: • Always use extreme care when handling fuel. • Never operate the blower without a properly Fuel is highly flammable functioning muffler and spark arrestor installed. - Page 8 When the Engine Starts Adjusting Engine Idle Speed IMPORTANT 1. Start the engine by following the procedures For maximum vacuum performance and operating described on the preceding pages. life, allow the engine to warm before use. 1. Run the engine at idle speed until operating 2.
-
Page 9: Routine Maintenance
• Wear hearing protection when operating this machine. • Never operate the blower if any component parts are damaged, loose, or missing. IMPORTANT • Operate the machine only at reasonable hours, not early in the morning or late at night when people might be disturbed. -
Page 10: Storage
• Before reinstalling the filter, inspect the condition of the fuel line. If damage or deterioration is noted, the machine should be removed from service until it can be inspected by a trained Bushranger™ service technician. CAUTION Never allow dirt or debris to enter the cylinder bore. -
Page 11: Troubleshooting
Often, a depleted, loose, or dirty spark plug is responsible for a Blower Vac not being able to start, but there can be a number of other reasons. Refer below to the list of potential problems you may encounter, along with suggested remedies. For servicing and all warranty work, contact your local authorised Bushranger™ dealer. Problem Likely Cause Suggested Remedy •... -
Page 12: Warranty
WARRANTY 1. Australian Consumer Law (REG. 90): The benefits to the consumer given by this warranty are in addition to other rights and remedies of the consumer under a law in relation to the good or services to which this warranty relates. Our goods come with guarantees that cannot be excluded under the Australia Consumer Law. -
Page 13: Ipl - Blower Vac Engine
IPL - BLOWER VAC ENGINE... -
Page 14: Spare Parts - Blower Vac Engine
SPARE PARTS - BLOWER VAC ENGINE Qty Ref No. Part No. Description 1-1 03010010077 MUFFLER SCREW M5X55 1-2 70030180012 AIR CLEANER COVER SCREW 1-3 70030040078 AIR CLEANER OUTSIDE COVER 1-6 03130010013 SPARK PLUG 1-7 02050010017 MUFFLER 1-8 02020160064 MUFFLER GASKET 1-9 03010010058 CYLINDER BOLTS M5X25 1-10 02090010011 FILTER ELEMENT 1-11 03020020043 BACKING PLATE SCREW 1-13 03020020012 SCREW M5X20 1-14 02050030023 IGNITION COIL... -
Page 15: Ipl - Blower Vac
IPL - BLOWER VAC... -
Page 16: Spare Parts - Blower Vac
SPARE PARTS - BLOWER VAC Qty Ref No. Part No. Description 2-1 70050010068 SUCTION TUBE NO.1 2-2 70050010069 SUCTION TBBE NO.2 2-3 03010060055 SCREW M5×16 2-4 03040020019 FLAT WASHER 2-5 70030030287 CONNECT COVER 2-6 03010060077 SCREW M5×10 2-7 70030180103 SAFETY SWITCH HOLDER 2-8 02050050002 SAFETY MICRO SWITCH 2-9 70030070035 MICRO SWITCH LEVER 2-10 03040050017 WASHER 6 2-11 70030180015 OUTER COVER LOCKING SCREW 2-12... - Page 17 NOTES...
- Page 18 NOTES...
- Page 19 NOTES...
- Page 20 Copyright © Roy Gripske and Sons Pty. Ltd. 2016. All rights reserved. 222. Images are for illustrative purposes only. Bushranger™ is a trademark of Roy Gripske & Sons Pty Ltd. PLP shall not be liable for technical or editorial errors or omissions contained herein, nor for incidental or consequential damages resulting from furnishing this material.