Table of Contents
Advertisement
Getting Started
Setting Up a Burst Signal
Programming
If you want to include this burst signal in your HP-IB program use the
example
following command lines. The comment lines starting with a # are not
required.
# Reset the instrument to start from a defined, default status.
*RST
# Switch off the automatic display update to increase programming
# speed.
:DISPlay
# Set the instrument to burst mode by selecting a burst count
# of 2. Choose double pulses. Select triggered mode by selecting
# PLL as the trigger source and set the burst repetition to 2 µs.
:TRIGger:COUNt
:ARM:SOURce
:ARM:PERiod
:PULSe:DOUBle
# Set the double pulse delay to 200 ns and the width to 100 ns.
:PULSe:PERiod
:PULSe:WIDTh
:PULSe:DOUBle:DELay
# Set the output amplitude to 2 Volts and the offset to
# 0.0 Volts.
:VOLTage
# Enable the output.
:OUTPut
42
OFF
2
# Set Burst mode with burst count of 2
INT2
# Set Triggered mode with PLL as
# trigger source
2US
# Set burst repetition of 2 µs
ON
# second channel generates double pulses
# per period
500NS
100NS
200NS
2V
ON
Advertisement
Table of Contents
