Table of Contents
Advertisement
Getting Started
Setting Up a Clock Signal
Programming
If you want to include this clock signal in your HP-IB program, use the
Example
following command lines. The comment lines starting with a # are not
required.
# Reset the instrument to start from a defined, default status.
*RST
# Switch off the automatic display update to increase programming
# speed.
:DISPlay
# Internal PLL has to be set as period source.
:ARM:SOURce
# Set the frequency to 25 MHz, the duty cycle to 50 % and the
# leading and trailing edge to 6 ns.
:FREQuency
:PULSe:DCYCle
:PULSe:TRANsition
# Set the high level to 2.5 Volts, the low level to 0.0 Volts.
:VOLTage:HIGH
:VOLTage:LOW
# Enable the output.
:OUTPut
34
OFF
INT2
25 MHZ
50
6NS
2.5V
0V
ON
Advertisement
Table of Contents
