Column Side-To-Side Movement Adjustment - Van Norman FG5000 Instruction Manual And Parts List

GRINDING HEAD ADJUSTMENTS (continued)

7. COLUMN SIDE-TO-SIDE MOVEMENT ADJUSTMENT:

noticed at the grinding head (when column is locked) can be eliminated by following this
procedure.
a. Remove access door at the rear of the machine.
b. Lower column until the rectangular bars are in the most accessible location.
c. Loosen jam nuts on the bolts located at the ends of both bars (Figure 35).
d. Adjust bolts out until slight pressure is put on the round support bars. Tighten jam nuts.
e. Apply a film of grease on contact area of the support bars.
Van Norman
5000/10000 FLYWHEEL GRINDER
Any side-to--side movement
36. 888-855-1789