Fill Coolant Tank - Van Norman FG5000 Instruction Manual And Parts List

1. Open front access door and slide coolant tank out of machine (Figure 11). Pour one quart
of #794-8011-40 Coolant Additive into the tank and add water to within approximately one
inch of the top. Slide coolant tank back into machine. Direct coolant drain hose to the inside
of the tank. After machine is wired, turn on coolant pump and set flow by turning valve
located outside the sheet metal coolant shroud (Figure 12).
Figure 11
CAUTION: Excessive build up of grinding sludge in the coolant may cause premature
failure of the coolant pump. Clean out coolant tank every 50 flywheels.
Van Norman
5000/10000 FLYWHEEL GRINDER

FILL COOLANT TANK

22.
Figure 12
888-855-1789